• Created by Unknown User (scassady@mit.edu), last modified by Unknown User (mzhengxi@mit.edu) on May 06, 2019 14:15

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

Tools:
  • Adjustable wrench
  • Mutlimeter
  • Small Screwdriver

 

 

  1. Prepare the following sub- assemblies vefore dressing:
    1. battery holder square
    2. middle square with DAQ mounted
    3. solder power on screw switch
  2. Run power wires through the top square to bottom square
  3. Mount battery holder square first, pick up power wires
  4. Connect power to battery, mount middle square
  5. Run antenna cable through the middle square
  6. Mount antennae (2) to the top square
  7. Mount top square
  8. Mount screw switch
  9. Add nuts on top plate
  10. Get batteries
  11. Prepare nose cone TCs in tip (if not already made)
  12. Silde on nose cone and bolt in place

 

  • No labels