Tools:
- Adjustable wrench
- Mutlimeter
- Small Screwdriver
...
- Prepare the following sub- assemblies vefore dressing:
- battery holder square
- middle square with DAQ mounted
- solder power on screw switch
- Run power wires through the top square to bottom square
- Mount battery holder square first, pick up power wires
- Connect power to battery, mount middle square
- Run antenna cable through the middle square
- Mount antennae (2) to the top square
- Mount top square
- Mount screw switch
- Add nuts on top plate
- Get batteries
- Prepare nose cone TCs in tip (if not already made)
- Silde on nose cone and bolt in place
Attach payload coupler to nose cone
- Obtain screws
- Torque them down
Attach payload stack to nose cone
Attach nose cone tip to nose cone (FIX THIS)
- Run thermocouples through washer
- Push washer in
- Screw on bolt
...