Versions Compared

Old Version 1

changes.mady.by.user Unknown User (maxkwon@mit.edu)

Saved on

compared with

New Version 2

changes.mady.by.user Claire Buffington

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Independent Assembly of the Tower

    1. Attach all electronics to the outer face plates

      1. Screw down all flight electronics to their respective places

        1. Pyxida center

        2. Telemega left

        3. MARSA right

      2. Wire electrical leads to the flight hardware

      3. Assemble the switch and secure it into place

        1. Attach the flight hardware electrical leads to the switch

      4. Attach the battery holders to the two outer face plates

        1. Run the power cables to near the battery holders and fix them down using (TBD)

      5. Attachment of Cameras by securing the holders to the Camera face plates

  2. Securing of the top base plate to the payload bulkhead

    1. Secure the piston through it

    2. (Allow Payload team to secure nose cone electronics)

  3. Attach assembled tower to the attached base plate on the payload bulkhead around the piston