November 28 Finocyl Core Cutting

Test	Kerf Input	Voltage	Speed	Offset	Notes	Pictures
0	?	? changed in middle of cut to 20 V	.03 in/s	.25	glue fell apart kerf was too big dimensions were off	N/A
1	.06 in	? either 20 V or ~18 V	.04 in/s	.25	glue fell apart wire was not cleaned in between cuts	N/A
2	.06 in	~18 V	.04 in/s	.25	glue fell apart (it appeared that the surfaces that were glued together were not flat, but had dents) wire cut right down seam it looked odd (it's the one on the right in the picture)
3	.06 in	~18 V	.06 in/s	.15	glue fell apart (it appeared that the surfaces that were glued together were not flat, but had dents) new offset avoided seam cut was clean

Changes to investigate:

use styrofoam?
- Dow Blue at Lowes is out
- https://www.insulation4us.com/xps-4-x-8-x-2-blue-board.html
cutting many cross-sections and stacking them
- more gluing involved
cutting quarters instead of halves to avoid glue issue
measure correct kerf