REs: Please include instrumentation needs for your subteams as well as the components (electronic, or otherwise) that would support them. Ideally, the format at the bottom of the page should make this compilation easier to interpret. Please remember that this compilation is for the RE(s) that will head the design of the PCB, so it important that they know what components to place on the board and any supplementary parts revealed through datasheets.
Liquid Prop
Load Cell
1
Requires an ADC and an amp (ADS7950SBDBT (Texas Instruments))
Model #:
Pressure Tap
3
Requires an ADC, preferably one with >=500 samples/second (higher sample rate for better thrust curve)
Model #:
Thermocouple
6
Requires an amplifier (ADS7950SBDBT (Texas Instruments))
K-type
Model #:
Accelerometer
1
Model #: ADXL1005 (Analog Devices)
Solid Prop
Load Cell
- 1
- Requires an ADC
- Model #:
Pressure Tap
- 1
- Requires an ADC, preferably one with >=500 samples/second
- Model #:
Thermocouple
- 5
- Requires an amplifier
- K-type
- Model #:
Payload
Load Cell
- 1
- Requires an ADC
- Model #:
Accelerometer
- 2
- Requires an ADC, preferably 1 MHz sampling rate
- Model #: ADXL1005 (Analog Devices)
Thermocouple
- 5
- Requires an amplifier
- K-type
- Model #: CHAL-015 (Omega)
Selected Components
- Pre-amplifier
- ADS7950SBDBT (Texas Instruments)
****************
FORMAT:
Subteam Name (i.e. Liquid Dev, Solid Prop, etc.)
Instrument 1 (e.g. Thermocouple, Load Cell, etc.)
- Detail (ratings, size, any requirements)
- Product number (if you have selected a specific instrument)
- Priority (how soon do you need it?)
- Further detail
Instrument 2
...
Instrument N
Selected Components (below are examples, name product numbers once you've determined then)
- Pre-amplifier
- ADC
- Noise filter