Team Tropical Escape has been hard at work this week with the first fabrications of each of our pieces. For it, we have been injection molding and creating/editing our molds.
B side
- B
To start off with our B, our previous post highlighted a bit of the journey to the first creations of it. We finally got a finished B with no flash utilizing the following parameters: ____
All the information for these tests can be found on this document (2 tabs for two different tests days).
Here are pictures of our produced Bs. Note, we have noticed the line in the top left edge indicating the meeting of two flowing points for the B. To eliminate this, we experimented with increasing shot size and decreasing the injection pressure. The results are shown below:
PICS of NEW Bs