Versions Compared

Old Version 16

changes.mady.by.user Joshua C Leighton

Saved on

compared with

New Version 17

changes.mady.by.user Joshua C Leighton

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Section

Modifications and Bodges:

Column
width500px

Power Board:

  • Vbat control (unlabeled between 12v and 6v) must be wired to pin 1 of its optorelay (immediately below the left main power connector)
  • Radio power control must be manually wired to a 2-pin KK connector (along with 5V) in the proto area
  • Optorelay for 6v control must be double up, and its associated resistor (vertical and to the left) halved to ~300 ohms

Arduino Shield:

  • Radio power control and VBat control must be manually wired (see tables above)
  • 12v control line transistor can be bypassed
  • motor driver is wired to serial uart 2
  • gumstix is wired to serial uart 1
  • tmp102 temp sensor resides on i2c bus
  • sbus wired to uart3
  • wiznet wired to default uart (shared with usb)
Column
width500px

Arduino Serial Details:

Column

 

Section

Self Power Reset

Image Added

Section

External Connectors:

Section

Additional Information:

 

Column
width500px

Tritech Depth Sounder:

  • Draws approximately 110mA at 12v
  • 3 pin impulse connector with pin 1 higher than the others and closer to pin 2 than pin 3
    • 1 - gnd
    • 2 - signal (rs232, 9600 baud)
    • 3 - power (vbatt ok, 10.5-20v)

Cruzpro Depth Sounders:

  • red - power
  • shield - gnd
  • green - signal
  • white - unused
Column
width500px

Duovero Header:

Column

 

...