...
Fabric Ripstop by the Roll 1.1 oz Ripstop Nylon, Uncalendared;
Size 46 nylon thread
Kevlar Webbing (check type)
Technora lines (check type)
Manufacturing Steps:
Cut out octagon (disk) and rectangle (band) pieces with extra seam allowance on all sides out of nylon ripstop (seam allowance of 1 inch, to be double-folded)
Fold ½ inch hems (double-folded) of the disk and band pieces and sew using double stitch with nylon thread
Cut out the radial Kevlar reinforcements and mark where the loops for the lines should end and fold
Sew ends of the band together
Sew on radial Kevlar reinforcements from center through each vertex of the disk and the bad, leaving sufficient gap between the pieces and leaving the loops on either end for the lines
Thread vent line through loops in the radial Kevlar reinforcements and finger trap in place; sew to secure
Cut out 39in of thin Technora for lines → lines should be 30.6in
Tie one end of line in bowline knot to chute through the created loops of the radial Kevlar reinforcements
Mark 30.6in on all lines
Tie bowline loop on end of thin Technora lines and check for length of 30.6
Run around and make sure chute works
...