...
Pre-Assembly: Build the Firebolt Jumbo
Make sure you are using safety googles, gloves, and all appropriate PPE.
Take a DRILLED & TAPPED 1/8 NPT PLUG (which has a 1/4-20 hole drilled and tapped through the middle) and thread a FIREBOLT into it using approximately 3 wraps of TEFLON TAPE.
Put two E-MATCHES through the hole in the 1/4-20 bolt and glue with 5 MINUTE EPOXY on the head end of the screw. You will need a POPSICLE STICK.
On the other end of the screw, you may be able to push a small amount of epoxy on, but don't get it in the plug's threads.
Put Once expoxy is dried, put a preselected amount of BLACK POWDER in a little packet of BLUE TAPE, with the e-match head inside of the packet.
...
Take the two TENDER DESCENDER BODIES and put the appropriate amount of black powder in them.
Close the bodies and thread a firebolt into each one, using approximately three wraps of Teflon tape.
...
Pre-Assembly: Pack the Main Parachute
...