...
- First experiment will test 0 degree angle shift between two layers of 3 TC's, X inches apart (to be determined)
- Potential Wiring Strategies:
- Single continuous loop, across different contours (see diagram A below):
- 3 lines of TC pairs according to blackboard diagram (see diagram B below):
- For first experiment, use the following jig (lasercut) for each layer (apply epoxy first, then use jig)
- Need diameters for contours on which to apply TCs
- Need diameters for contours on which to apply TCs
- Consider using 3D printed support structures (see below)
- Concern for strength/adhesion on launch
- Ideally thin, and epoxied along inner surface of NC
- Combine jig and ring for mounting (void) and support
2/27/2019
Determined first method of thermocouple attachment: steel rod jig w/ aluminum tape or string quick-release knots
Determined distance from base of NC to DAQ-TC interface: height = 3.08", ID =